Argox F1 Bedienungsanleitung PDF herunterladen (Seite 46)

6. Thread the cutter cable through hole (8) and route it to the

JP16 connector (CUTTER) on the X-1000VL/ X-2000V/

X-2000V Zip main boards, or to the JP14 connector

(CUTTER) on the main board of X-3200/ X-3200Z/

X-3200E/ X-3200ZE/ X-2300E/ X-2300ZE.

7. Turn on the printer.

8. For the X-2000V/ X-2000V Zip/ X-3200/ X-3200Z/

X-3200E/ X-3200ZE/ X-2300E/ X-2300ZE models with

LCD, set the parameter of “CUTTER INSTALLED” on the

LCD to the ON position. For the X-1000VL model, ignore

this step.

After the cutter is installed, install media and ribbon.

1. Put the media end on the roller.

2. Close the print head latch.

3. Hold the PAUSE button and turn on the printer.

4. Release the button when the cutter starts cutting.

5. After cutting, the printer will feed the label for 8 inches.

Note: The procedure above is for first time installation or after

cutter jam. Normally the procedure for loading the media

through the cutter is:

1. Put the media end on the roller.

2. Close the print head latch.

3. Turn on the printer.

4. Press the FEED button to feed the media end through

the cutter.

Rotary Cutter and Guillotine Cutter Settings

Before printing and cutting tasks, please make sure whether the

cutter in use is Rotary Cutter, or Guillotine Cutter. Then select

proper settings via Seagull Driver for printer. The following

installation steps are based on X-3200 as an example.

1. Check X-3200 driver. Go to the prompt of Printer Properties,

click on the tag, “Tools’:

2. Click the “Configure” setting of driver, select “Cutter Setup”:

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 62 63

Keine Kommentare

Argox F1 Bedienungsanleitung Seite 46