Argox F1 Bedienungsanleitung PDF herunterladen (Seite 37)

MEMORY FULL READY

Printer buffer full due to loaded soft fonts,

graphics or forms. Check data format. Call

for service.

SENSOR O.R. READY

Media calibration is out of range for sensor

detection. Make sure media is loaded and

media sensor locates under media.

PRINT HEAD

HEAT

MEDIA

Printing job will start until the temperature

of TPH goes down.

HEAD OPEN READY

Print head latch is not closed. To print label

the head latch must be closed.

Transmission Problems

If the host shows "Printer Time out"

1. Check if the communication cable (parallel or serial) is

connected securely to your parallel or serial port on the

PC and to the connector on the printer at the other end.

2. Check if the printer power is turned on.

If the data has been sent, but there is no output from the printer.

Check the active printer driver, and see if Seagull Driver for your

Windows system and the label printer has been selected.

Recovery

After correcting problems, simply press the CANCEL button or

restart the printer. Make sure the LEDs are not blinking and

remember to resend your files.

Printer Maintenance

Vertical streaks in the printout usually indicate a dirty or faulty

print head. (Refer to the following examples.) Clean the print head.

If the problem persists, replace the print head.

For unstable ribbon roll rotation, check the label path and make

sure the head latch is securely closed.

Poor printout quality:

 The ribbon may not be qualified.

 The media may not be qualified.

 Adjust the Darkness (heat temperature).

 Slow down the print speed.

 Refer to the following and clean the related spare parts.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 62 63

Keine Kommentare

Argox F1 Bedienungsanleitung Seite 37