Argox F1 Bedienungsanleitung PDF herunterladen (Seite 62)

123

The simplest way to connect to other hosts (not PC compatible) or

terminals is:

Printer Terminal/Host

Pin 2- RxData ……… TxData

Pin 3- TxData ……… RxData

Pin 5- Ground ……… Ground

In general, as long as the data quantity is not too large and you

use Xon/Xoff as flow control, it will be problem free.

Baud rate: 1200, 2400, 4800, 9600(default), 19200, 38400,

57600,115200 bauds. (Programmable by

command)

Data format: always 8 data bits, 1 start bit and 1 stop bit.

Parity: always non parity

Handshaking: XON/XOFF as well as CTS/RTS (hardware

flow control).

If you run an application with the bundled printer driver under

Windows and use the serial port, you should check the above

parameters and set the flow control to "Xon/Xoff "or "hardware".

124

Parallel (Centronics)

The parallel port is a standard 36-pin Centronics connector. Pin

assignments are as follows:

Pin Direction Definition Pin Direction Definition

1 In /STROBE 13 Out SELECT

2 In Data1 14,15 NC

3 In Data 2 16 - Ground

4 In Data3 17 - Ground

5 In Data4 18

6 In Data5 19~30 - Ground

7 In Data6 31 NC

8 In Data7 32 Out /Fault

9 In Data8 33~36 - NC

10 Out /ACK

11t Out BUSY

12 Out PE

1 2 ... 57 58 59 60 61 62 63

Keine Kommentare

Argox F1 Bedienungsanleitung Seite 62