Argox F1 Bedienungsanleitung PDF herunterladen (Seite 26)

32. Mac Address

33. SNMP

34. DIP switch

Switch ON OFF

Direct

Thermal

Default

35. Font Image

Remark：

What continue after the parameters are test patterns of print

head.

Resetting to Factory Default Settings

To reset the printer to factory default settings:

1. Turn off the printer.

2. Press and hold the CANCEL button and turn on the

printer.

3. When “RESET …” is displayed on the LCD and the

READY indicator blinks, release the CANCEL button.

(The Ethernet models will first prompt “ETHERNET CARD

INITIALIZING” on LCD after Power-on and then show the

“RESET …” message as described above.)

4. When “READY” is displayed on the LCD, the READY

indicator stops blinking but remains illuminated.

5. The following information is now back to defaults:

 Label parameters

 Heat (Darkness)

 Speed

 Symbol set (language)

 Others for specific emulation

Notes:

1. For X-1000VL, the steps about LCD can be ignored.

2. Be cautioned that this will reset all printer settings back to

defaults; if possible, print the configuration label in

advance before reset.

3. All settings stored in FLASH memory are retained even

after turning off the printer.

4. You must perform the calibration after resetting the printer.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 62 63

Keine Kommentare

Argox F1 Bedienungsanleitung Seite 26