Argox F1 Bedienungsanleitung PDF herunterladen (Seite 16)

3. Close the top access door and turn on the printer or press

the FEED button if the printer is already on. The printer will

then feed the labels through the cutter automatically.

(Figure 3)

Note: The FEED button does not make the printer cut. To

enable Cutter function, set by the LCD panel

Cutte

Adjust Position of Label Sensor

Function of the label sensor is to detect the gap, notch, or holes of

labels, to help the printer for accurate print positions and label

length. For labels with gaps, label sensor can be positioned

wherever media locates. If labels with notches or holes are in use,

follow the steps below to check position of the label sensor:

- Unlatch the Print head Latch. (as Figure 2 in Section –

Standard Mode Loading Media)

- Pull down Paper Sensor Position Lever (as Figure 3 in

Section – Standard Mode Loading Media), to horizontally

adjust position of label sensor.

- Make sure the Media sensor position mark locates right on

notch or hole of labels.

Check below.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 62 63

Keine Kommentare

Argox F1 Bedienungsanleitung Seite 16