Argox X-2300E Betriebsanweisung PDF herunterladen (Seite 5)

Ethernet Printer Technical Manual November 10, 2010

2. Additional Commands

Parameter types:

- None: no parameter is required

- Signed integer. e.g. +100 or –23

- Unsigned integer. e.g. 32

Signed byte. Just one byte binary data. e.g.

+3 is represented as 0x03(03H), and –1 as 0xff (0FFH).

Command Description

<ESC>KIZA

*Enable/disable the switch detection of the print head if it is opened.

*Syntax: <ESC>KIZAm

*Parameter:

m = 0; disable the switch detection of print head if it is opened

(default)

m= 1; enable the switch detection of print head if it is opened

If this function is enabled, the label auto-calibration will be performed when the print head is

closed.

<ESC>KJA Request the printer status through Ethernet to be displayed on the web

page. Information about the printer status is listed in TABLE1.

<ESC>KJB End Job

<ESC>KJH Enable the printer to check if Ethernet card is alive or not every second.

<ESC>KJI Disable the printer to check if Ethernet card is alive or not every second.

<ESC>KJJ Start Job

<ESC>KJK *Reset the printer function.

*Syntax: <ESC>KJKm

*Parameter:

m=0 disable the reset function (default)

m=1 enable the reset function

This command is for printer configuration.

<ESC>KJL *SNMP broadcasted function setting.

*Syntax: <ESC>KJLmnq

*Parameter:

m= 0, disable the Ethernet card to enquire to reset the printer

(default)

m=1, enable the Ethernet card to enquire to reset the printer.

n= 0, disable the SNMP function (default)

n=1, enable the SNMP function

q= 1~9 seconds;which SNMP enquire for the

1 2 3 4 5 6 7 8 9 10 ... 50 51

Keine Kommentare

Argox X-2300E Betriebsanweisung Seite 5