Argox A-2240E Spezifikationen PDF herunterladen (Seite 19)

Configuration and Configuration

This section discusses calibration, printing configuration and

resetting the printer to factory defaults.

Performing Calibration and a Configuration

Report

1. Turn off the printer power.

2. Press and hold the feed button while turning on the power, until

the printing motor is activated.

3. Calibration is performed while the printer automatically feeds

the label stock for a certain length, the printing motor suspends

for one second and then prints out a configuration profile.

4. The profile includes firmware version, ROM checksum,

RS-232, thermal transfer/direct thermal settings, hardware

configuration, and font types.

5. At PPLB emulation, the printer enters character dump mode.

To exit from dump mode, press the feed button again. (If you

accidentally print the label without exiting from dump mode in

advance, you need to turn on the printer or press feed button

again to print normally.)

Important! You must always carry out calibration when

changing media. Failure to do so will result in improper

detection by the label sensor.

Retuning to Factory Default Settings

1. Turn on the printer and wait for 5 or more seconds.

2. Press the "Feed" button for 10 seconds, and the "Ready"

indicator and "Power" indicator will go off in order.

3. While two indicators become lit again, release the FEED

button.

4. The printer will come back to the factory default settings.

Note: Revise the factory default settings that stored in

flash, even if turn off the power source cannot be

eliminated.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Keine Kommentare

Argox A-2240E Spezifikationen Seite 19